a 16035 vineyard blvd morgan hill, ca 95037 p 408 225 4314 f 408 225 2079 e www.allsensors.com all sensors all sensors ds-0165 rev c mkt date mfg date eng date qa date approvals as is with change as is with change as is with change as is with change ? 5 inh2o full sacale to 100 psi full scalepressures ? 0.5 % linearity ? small lcc footprint ? rohs compliant general description features surface mount basic pressure sensors the basic serices of pressure sensors use a silicon micromachined (mems) pressure sensor in the most basic confguration. the package is a ceramic surface mount confguration to provide the smallest footprint possible. best temperature compensation is realized when the sensor has a constant current excitation. this series is intended for use with non-corrosive, non-ionic working fuids such as air, dry gases and the like. specifcations are written for constant voltage of 3.0 volts. the output of the device is ratiometric to the supply voltage. ? medical instrumentation ? environmental controls ? hvac applications pinout pin 1: vs pin 2: +out pin 3: n.c. reserved pin 4: n.c. reserved pin 5: n.c. reserved pin 6: n.c. reserved pin 7: -out pin 8: gnd lp package lf package pin 2 1 8 7 6 3 dimensions: inch [mm] back side (common to lp and lf packages) part marking part marking port on gage de vi ces only part marking l05g - 5 inh2o l10g - 10 inh2o 001g - 1 psig 005g - 5 psig 015g - 15 psig 015a - 15 psia 030g - 30 psig 060g - 60 psig 100g - 100 psig physical dimensions equivalent circuit 3.81 .150 .145 3.68 0.89 .035 .035 0.89 2x 1.4 .055 .0352x 0.89 7.62 .300 sq. .165 4.19 2x pin 1 c l solder pads are pre-tinned vs +out -out gnd
ds-0165 rev c specifcation notes note 1: a ll p ar a meters are measured a t 3.0 volt excit a tion , for the nominal full sc ale pressure and room temper a ture unless otherwise specified . p ressure mea surements are with positive pressure to the single port configur a tion . note 2: s hift is rela tive to 25c. note 3: s hift is within the first ye ar of oper a tion . note 4: m easured a t one - half full sc ale r a ted pressure using best str aight line curve fit . note 5: t he sp an is the a lgebr aic difference between full sc ale output volt a ge and the offset volt a ge . note 6: p ar a meter is char a cterized and not 100% tested . m inimum and m a ximum v a lues indic a ted as a design reference . all sensors reserves the right to make changes to any products herein. all sensors does not assume any liability arising out of the application or use of any product or circuit described herein, neither does it convey any license under its patent rights nor the rights of others. supply voltage vs lead temperature (soldering 2-4 sec.) 6 vdc 270c pressure sensor characteristics maximum ratings temperature ranges operating storage humidity limits -25 to 85 c -40 to 125 c 0 to 95% rh (non condensing) environmental specifcations minimum parameter (1) ofset voltage temperature efect on ofset (2) temperature efect on resistance (2,6) temperature efect on span (2,6) linearity error (4,6) hysteresis error (6) position sensitivity (bst-l10g-xx) (6) input resistance (6) output resistance (6) long term stability of span (3) nominal 1.0 3 2600 -2200 0.2 0.01 0.01 3.3 3.3 0.1 maximum 5.0 -- 3300 -2700 0.5 0.05 0.03 4.0 4.0 -- units mv uv/v/c ppm/c ppm/c % fss % fss % fss kohms kohms % fss common performance characteristic -- -- 2300 -1700 -- -- -- 2.7 2.7 -- standard pressure ranges operating pressure 0 - 5 inh2o 0 - 10 inh2o 0 - 1 psi 0 - 5 psi 0 - 15 psi 0 - 15 psia 0 - 30 psi 0 - 100 psi ported part number csm-l05g-lp csm-l10g-lp csm-001g-lp csm-005g-lp csm-015g-lp csm-015a-lp csm-030g-lp csm-100g-lp non-ported part number csm-l05g-lf csm-l10g-lf csm-001g-lf csm-005g-lf CSM-015G-LF csm-015a-lf csm-030g-lf csm-100g-lf nominal 8.40 1.65 22.8 12.0 4.40 4.40 2.30 0.96 units mv/inh2o mv/inh2o mv/psi mv/psi mv/psi mv/psi mv/psi mv/psi proof pressure 3 psi 3 psi 5 psi 15 psi 45 psi 30 psi 100 psi 200 psi std dev. 1.10 0.19 2.60 1.50 0.58 0.58 0.30 0.13 sensitivity (1)
|
